gorilla
06-28-2007, 10:02 AM
How To Roll A Blunt
Gorilla Style
1. Get a blunt and weed. I used a vanilla Game blunt and a little more than a gram of weed.
2. Break up the pot to a very fine consistency, but not powder.
3. Unwrap the blunt and wet the whole thing with your mouth. I licked half of it for the picture so that the difference would be noticeable.
4. Start to unravel the outer leaf beginning at the mouth piece. This may take a bit of practice.
5. After you've removed the outer leaf, remove the brown piece of paper that is wrapped around the mouthpiece. Discard of this.
6. Slice the blunt down the middle. Discard of the tobacco.
7. Replace with weed. Spread it evenly throughout the blunt, so that your finished product is not bumpy.
8. Roll the blunt. Depending on how much weed I use, I usually get one or two rolls before I lick what paper is left. I believe that it is very important to get a nice roll on this inner paper.
9. Lick the outer leaf on the side that will be pressed against the blunt. I like to position the leaf as it is shown in the picture. Where I start rolling the blunt into the outer leaf will be my mouthpiece, and it will not unravel while smoking.
10. Don't roll the outer leaf tight, and you shouldn't have to if the inner blunt paper was rolled correctly.
11. Trim off any excess paper. I usually use as little paper as possible, But I didn't worry about it for this demonstration. Get your lighter ready. ;)
12. Smoke that shit, dude.
:pass:
Gorilla Style
1. Get a blunt and weed. I used a vanilla Game blunt and a little more than a gram of weed.
2. Break up the pot to a very fine consistency, but not powder.
3. Unwrap the blunt and wet the whole thing with your mouth. I licked half of it for the picture so that the difference would be noticeable.
4. Start to unravel the outer leaf beginning at the mouth piece. This may take a bit of practice.
5. After you've removed the outer leaf, remove the brown piece of paper that is wrapped around the mouthpiece. Discard of this.
6. Slice the blunt down the middle. Discard of the tobacco.
7. Replace with weed. Spread it evenly throughout the blunt, so that your finished product is not bumpy.
8. Roll the blunt. Depending on how much weed I use, I usually get one or two rolls before I lick what paper is left. I believe that it is very important to get a nice roll on this inner paper.
9. Lick the outer leaf on the side that will be pressed against the blunt. I like to position the leaf as it is shown in the picture. Where I start rolling the blunt into the outer leaf will be my mouthpiece, and it will not unravel while smoking.
10. Don't roll the outer leaf tight, and you shouldn't have to if the inner blunt paper was rolled correctly.
11. Trim off any excess paper. I usually use as little paper as possible, But I didn't worry about it for this demonstration. Get your lighter ready. ;)
12. Smoke that shit, dude.
:pass: